Stuck T1 slide

More
29 七 2019 14:49 #1794 by Pete Burkindine
Stuck T1 slide was created by Pete Burkindine
Howdy!

I am trying to restore a horn to playing condition. It has a stuck first valve slide, Bb side. I have been hitting it with heat and WD-40 daily for about a week with no progress. I'm wondering if folks can give me other advise on getting this sucker loose. I pull by running a polishing cloth through the crook and jiggling, pulling hard as I can.

The horn does not have enough value left to consider sending it off for repair; I need a DIY at-home solution.

Thanks!
- Pete

Please 登入 or Create an account to join the conversation.

More
25 八 2019 18:15 #1796 by Anne Maliborski
Replied by Anne Maliborski on topic Stuck T1 slide
I am not a repair person, so I might not have all the fancy tools that may be out there. But I have un-stuck many slides since I buy and sell horns. I have a rawhide mallet that I use to tap on the slide ferrule after heating up the slide with a blow dryer for a long while. I use a cloth to yank the slide out, the same way you have been doing. Sometimes I also try to push the slide IN a bit !!! ( as wrong as this may seem!) Sometimes it's just a matter of loosening the crusty stuff on the inside of the slide, and pushing it in will loosen it just like pulling it out will do. Also, I never used WD-40. My husband has some penetrating oil in an orange labeled can. (He is a good mechanic) I've tried this oil and it doesn't seem to do much of anything, just like the WD 40. Heat, tapping, and lots of pushing in or pulling.

Please 登入 or Create an account to join the conversation.

Time to create page: 0.398 seconds
Cookies make it easier for us to provide you with our services. With the usage of our services you permit us to use cookies.
Ok